is 1 Hour.
Click here to download fitting instructions
First unpack the roll bar and check that all the pieces are
undamaged.
Then attach the two rear arms to the main bar, making sure
to line up the holes to allow the screws to be put in. To fix the two rear arms
to the rest of the roll bar get the allen key screw and washer as shown below.
Next loosely screw in the two bolts into the two holes and
then tighten with the larger allen key supplied.
Now repeat for the other rear arm.
Next get one of the metal joining plates, four smaller allen
key bolts and the accompanying washes and bolt in as shown in the photo below.
Each side should look similar to the photo below.
Next carefully place the roll bar onto the pick up bed sides
and mark the area where you need to drill. Once the holes are marked remove the
roll bar and drill through the top of the pick up bed sides and clean the hole
of any loose filings.
Finally place the pads provided under the roll bars feet and
use the remaining bolts to secure the roll bar in place. Tighten all bolts and
polish any marks off the bar. Stand back and admire.