Ply Lining your van makes perfect sense. By fitting a ply lining kit you immediately add resale value to your Crafter LWB. It will stop internal damage caused by shifting loads. At resale time you may wish to remove the kit and present the van bodywork in almost new condition. So the initial cost of ply lining is recovered as much as 10 times over.
All kits are made from the very best quality Birch plywood and come pre drilled, with 9mm floors, 6mm sides and door panels, all fixings including aluminium door trims (if applicable) wheel arch boxes and instructions are supplied, we also supply sealant to finish off.
Fitting time approximately 1 1/2 - 2 hours.
This kit comprises of:
Full height side panels in 6mm birch ply.Side loading door top and bottom panels in 6mm birch ply.Rear door top and bottom panels in 6mm birch ply.Full floor in 9mm birch ply.Fully assembled wheel arches in 9mm birch ply.Aluminium door thresholds (pre drilled).Tube of frame sealant.All fixings are supplied with full set of easy to follow fitting instructionsFor LWB VW Crafter’s only.
The above image displays a generic Ply Lining Kit & is for illustrative purposes only. Please note that some of the pieces shown are not part of this particular VL kit.